• Dismantled Machine tool

  • Surveyed headstock spindle and bearings for axial and radial clearance

  • New bearings where needed due run out and lift

  • Headstock gears, pinions, and pulleys will be surveyed. No need to be replaced but found input shaft key way where worn replaced with new

  • Hand scraped and aligned bed square and parallel to spindle

  • Scraped saddle to bed, keeping saddle square to spindle

  • Way ground top, leading edge of “X” axis ways

  • Scraped, flaked and mastered bottom ways of cross slide to saddle

  • Machine scraped and aligned “Z” axis compound ways

  • Precision aligned compound square turret to top of compound slide

  • Scraped and flaked “X” and “Z” axis gibs to have full adjustment

  • Remanufactured  “ X” and “Z” axis ballscrews

  • Installed new thrust bearings on “X” and “Z” axis ballscrews

  • Scraped and aligned ball screw brackets for flatness (“X” and “Z” axis)

  • Precision aligned “X” and “Z” axis ball screws



  • Cleaned and inspected hydraulic systems

  • Replaced all hydraulic hoses, filters and sight glasses

  • Removed and replaced all lubrication meters and lines, retrofit with Lube LHL x 100 grease system and Generation 3 LHLPX1 retrofit panel

  • Supplied and installed all new way wipers

  • Installed new spindle drive belts

  • Painted machine to customers color code